ACCEL Motorcycle Knowledgebase

To search the knowledgebase, enter a specific word or phrase to search for. To find tickets that you submitted, search for your email address. You can also use the drop-down to choose a date range for display.

If you don't find the answer to your question in our knowledgebase, submit your question to our techs.

Search Terms:
 Search Email Address:
 Date Range:


To page through the knowledgebase (or the knowledgebase search results), use the numbered paging links found at the top and bottom of the grid. To re-sort the grid by ID or Date/Time, click on the ID or Date/Time link at the top of the column.

To view the full question and answer, as well as any attachments or links, click the ticket number.

123456
Ticket #Date/TimeQuestion
1628047/20/2007 11:09:17 AMJust purchased #35496 ignition set up for single fire what settings on the ignition shoud i be using
1068878/26/2004 1:07:59 AMI bought a NEW ACCEL PETCOCK to replace damaged petcock on my motorcycle. I missplaced (LOST) ACCEL PETCOCK GASKET to gas tank and can not locate another gasket. Can you sell me a replacement gasket? if not where can I find one? THANK YOU
961442/18/2004 12:00:00 AMI have a gasket set #38443. This set has steel type cyl base gaskets and rocker box gaskets.They seem to have a coating on them.Do I need to apply a gasket sealer to the steel gasket?Can you give me a web site that I can show my customer because he thinks that James gaskets are the way to go.I do-not have a catalogue of my own I get your product from Preston Cycle Products. Thanks for your time.Kanally,s Engine Service.
9226412/30/2003 12:00:00 AMI would like to upgrade my coils with accel coils. Could you recommend a set. Thanks JC
870448/30/2003 12:00:00 AMHow to adj. voltage regulator # 201105 & 201105C OEM # 74510-64 Problem: Replaced battery,and generator. when checking charging system at 3000 RPM., found voltage at battery 15volts and current from armature to regulator 18amps. generator mfg. recomends not exceeding 10amps draw from gen. thank you SM
834097/5/2003 12:00:00 AMDoes mallory have coils and wires for the Z1 ?
540679/14/2002 12:00:00 AMI have the stock electrical system of generator,v/reg, points, condensor and coil. I would like to get away from this set-up, mainly, and you're going to laugh, because I've had this same bike for 23 years and my eyes aren't as good as they used to be for adjusting points. Any suggestions would be appreciated. Joe Gyde
315422/28/2002 12:00:00 AMDo you make a hot coil & plug wires for my 99 fuel injected RoadKing?Regards,TomKelly
312592/24/2002 12:00:00 AM Hello, My name is Chris and I need to find some spark plug wires for my bike. H-D changed the coil on the 2000's so they use a long straight boot at the coil. I can't seem to find aftermarket wires. Can you bail me out of a jam? Thanks for your time. CHRIS
312482/23/2002 12:00:00 AMWhere can I find the "Accel 300+ Race Wire" for my 2001 Road King. I have not seen these advertised in catalogs.
299492/7/2002 12:00:00 AMWhat type of coil(s) do I need? What is your part # or any other retrofit coil should I use?What type of 12 volt source do you sugggest?I currently have a batteryless system whith a generator? Please send me your Accel Custom Motorcycle Parts Catalogueto: Jared Jackson C/o Fleet Capital Corp. 1 South Wacker Dr. #1400 Chicago, IL 60606 Phone # 312-827-4213
298622/5/2002 12:00:00 AMiam looking for those spark plug wires that glow when the eng is running.
292692/3/2002 12:00:00 AM 1983 yamaha 2cyl one coil 3.9 to 4.0 ohm ,could you tell me what part number to replace stock coil,bike has no points ,cdi?
289861/30/2002 12:00:00 AMLooking and hoping that Accel has a wire set for this vehicle. Please advise. Thank you.
289221/29/2002 12:00:00 AMI would like to replace my coils and sparkplug wires with your product. My original wires have a rubber boot with a big seal at the top. the plugs are recessed about 3 inches into the motor. I would like to Know if your Coil/wire kit for this bike will have the same wire setup with the extended plug end and rubber seal to keep crap out of my plug recess. I have a picture from my manual to show this better but couldn't figure out how to get it into this reply. If you have an E-mail address I could send the scan which definately shows what I'm...
289211/29/2002 12:00:00 AMI would like to replace my coils and sparkplug wires with your product. My original wires have a rubber boot with a big seal at the top. the plugs are recessed about 3 inches into the motor. I would like to Know if your Coil/wire kit for this bike will have the same wire setup with the extended plug end and rubber seal to keep crap out of my plug recess. I have a picture from my manual to show this better but couldn't figure out how to get it into this reply. If you have an E-mail address I could send the scan which definately shows what I'm...
288921/28/2002 12:00:00 AMThis is a customers bike. I installed an Accel stator on November, 17 2000. He brought the bike back on January, 25 2002. The stator failed, not charging. Who takes care of the part warranty, you or the dealer I purchased it from. He knows the labor isn't covered. Thank You for your prompt reply, Robert Harvey.
288881/28/2002 12:00:00 AMCan I purchase only one coil or do I have to buy another complete kit just to replace one bad coil?
287741/23/2002 12:00:00 AMI need a set of 12:1 pistons. Can you help me... Al.......
287211/22/2002 12:00:00 AMI need a wiring diagram for an accell rev master rev limiter
123456
© 2009 Prestolite Inc. | Warranty Info | Privacy Policy | Links

Mr. GasketACCELHaysLakewoodMalloryACCEL DFIACCEL MotorcycleMallory MarinePrestolite Wire