|
|
Reply from Rep:
FI = Fuel Injection
|
|
|
Reply from Customer:
Were will I see this FI light up at , I have never seen this before . My owners manual shows all points to were and what lights up and what it stands for , but don't recall anything for Fuel Injection !
|
|
|
Reply from Rep:
Contact your Harley Dealer.
|
|
|
Reply from Customer:
That's a odd answer , seeing how it's in YOUR installation instructions ?
|
|
|
Reply from Rep:
What are you installing ? Give more info..
|
|
|
Reply from Customer:
Sorry about that I'm sure that would help , ACCEL Self Learning Module #SLM04 . It's all installed and only tested on battery power and that fuction worked according to the instructions red / green blinking . I will reinstall my fuel tank tonight and start it and be looking for the last part of the instructions were I should see this FI light and after 90 seconds module go to blinking green only. If all goes right then good to go , I should think. That's why I was asking about the FI light , I know about the RED / GREEN as to it's location not sure of the FI were abouts ? Thanks
|
|
|
Reply from Rep:
You should see the FI light on you gauges. Most likely on the speedometer. It might flash the "check engine light" on your model. Let me know if you have anymore questions after you have started the bike and let it run for a few minutes. Don't forget to disconnect the battery for 15 minutes to reset your ECU.
Thanks,
Jason
216-658-6336
|
|
|
Reply from Customer:
Thanks for the heads up about the disconnecting of the battery , never read a thing about that ! Is this something that is required by Accel Module or just common knowledge ( Good Practice ) ?
|
|
|
Reply from Rep:
Good Practice. Thanks, Jason 216-658-6336
|
|
|
Reply from Customer:
Jason you were correct the " Check Engine Light " after starting flashes then stays out . The green / red flashes back and forth and then stays green and all this takes place after each start. I'm looking forward to see how it does on the road , few more things to finish up and will let you know. Thanks for your help , one last thing it would be nice if the wire harness was a bit longer in order to mount back by the ECU instead of up close to the engine with all the heat . Thanks Again
|
|
|
Reply from Rep:
: )
|
|
|
|